Laser engraving machine maintenance precautions
Date£º2010-06-18 Read£º3081
Any piece of equipment, good quality is its natural advantages, and the correct use and maintenance is an important condition for its acquired. The proper use and maintenance of the equipment can better play its efficacy, while also able to effectively extend its service life.
Laser engraving machine in the use of maintenance, to note that the following matters:
A, X slide rail oil method
¢Ù turn off the laser machine, use the slider on the hex wrench to remove the lens (protection lenses.) Remove the lens exposing four Hex were removed, then the slider and belt out, in the fixed linear rail Yiyi nail fold, the (careful not to touch the tap guide) (Do not remove the slider ) then grasp the rail back to place, showing the slider and the rail joints, if the slide in oil, in time to see a shiny ball, put the oil in the lubricating oil out of the needle point add the oil with a wooden toothpick into the gap, followed by refueling with scroll the slider, as far as possible so that each ball touches the oil.
¢Ú to complete oil to slide back and forth rolling about on the rail, then rail to be installed first time, Do not pay attention to the first fixed rail, we should all installed fixed-nail to maintain the level of the belt in a fixed and the slider fixed, then the lens installed, dimming about X's whereabouts path is completed.
Second, regular cleaning of the components:
¢Ù mirror: a total of three. Two open, one closed and open the lens for some time each cadmium (based on usage) (usually in a month or so, stick with medical alcohol wipe the lens paper or cotton)
¢Ú cooling fan: the machine for 3 to 4 months or so, to open the lid, when the laser tube and the fans have a lot of dust and need to wipe off, wipe clean and then immediately after installation.
Third, the bearing oil considerations.
Cotton fibers on the surface dust wipe the bearings, the oil suction tube with a needle syringe, with needle slowly into the bearings, rotating slowly in the oiling bearings can be.
Fourth, adjust the lifting platform
Because the X rail is horizontal, so the platform with a steel measuring tape can be, would be to turn off the machine, the four corners of the platform were measured out with a steel ruler vertical distance above the platform is fixed with the nail, the nail below is adjusting.
Five fonts are carved in the appearance of ghost
¢Ù hand feel for the machine next to the elastic belt to see X-axis gear wear, listen to X axis of the rail movement is a harsh sound.
¢Ú The first belt, gear were removed, clean up, move the slider then the machine installed Shanghao lubricants, appropriate adjustment in the engraving text, if there is not the same phenomenon, then if there is to open the sslaser file, adjust the parameters.
Six large-format sculptures around, significant strength when different
First look at whether the plane and the lens to maintain the level, look at the optical path in the right, if the problem solved in time, if not, take a look at the voltage stability of the local instability, to see how many degrees room temperature, generally room temperature, cooling the laser tube will have low benefits, if more not to contact the manufacturer.
|
